Gas work leaves no room for close enough. We install, extend, and repair gas lines to code for ranges, dryers, water heaters, fireplaces, generators, and grills.
Running gas to a new range, a dryer, a fireplace, a standby generator, or a patio grill. We size the pipe for the total load on the system, not just the one appliance, so nothing starves when everything runs at once.
When the gas company finds a leak, we repair or replace the failed section and check every connection before anything goes back in service. Old black iron, corroded fittings, and improper flex connections are the usual culprits.
Get everyone out of the building before you do anything else. Do not flip switches, unplug anything, or use a phone inside. A spark is all it takes. Call the gas utility from outside, then call us.
Every gas job is done to code. When a job needs a permit, we pull it and have the work inspected, which protects you at resale and with your insurer.
Every connection we touch is soap tested for leaks before the gas goes back on. No exceptions.
Appliances reconnected, and the work explained to you before we leave.